- CANNOT LAUNCH THE MODELSIM ALTERA SOFTWARE SOFTWARE
- CANNOT LAUNCH THE MODELSIM ALTERA SOFTWARE CODE
- CANNOT LAUNCH THE MODELSIM ALTERA SOFTWARE SIMULATOR
If you've not done any of your own code to trigger this and you're just trying to launch the application, contact the vendor and file a support request.
CANNOT LAUNCH THE MODELSIM ALTERA SOFTWARE SOFTWARE
If you are using Modelsim-Altera, you will not need to do this. ModelSim 1Cant launch the ModelSim-Altera software Quartus II Modelsim modelsim Tools-> Options -> General -> EDA Tool Optio. Go to Assignments Settings EDA Tool Settings Simulation, and. But it might be all wrapped up in some sort of abstract widget management code too it's not trivial to hunt this down unless you're lucky. You should get a message from Quartus saying 'This file is read-only and cannot be edited'. 'General' -> 'EDA Tool Options' 'ModelSim-Altera' 'ModelSim-Altera' 'C:\altera\13.1\modelsimase\win32aloem'. Open the interface as follows, selectGeneral -> EDA Tool Options -> Modelsim-Altera (I downloaded the Modelsim when I installed Quartus II, which is the. First, you must tell Quartus that you wish to use the ModelSim-Altera simulation tool. I'd guess it would in turn be done with list, a widget name, etc. At a guess, it's the empty value that is passed in from the menu callback identified as: ::Vsimmenu:efaultMenuPostCmd.
when compiling with ModelSim in Quartus II : Cant launch the ModelSim-Altera software-the. If cid is unexpectedly empty, you're going to be tracing it back. Solve the problem that ModelSim cannot be used in Quartus II. Check particularly if you need to say global _clients or variable _client or something like that (maybe involving upvar). To launch Active-HDL from Quartus II, click on Tools Run Simulation Tool.
CANNOT LAUNCH THE MODELSIM ALTERA SOFTWARE SIMULATOR
The only way to work out whether _clients is right is to look at the code (which you've not shown us). Active-HDL simulator can be run directly from Intel Quartus software using. In particular, we see that you were trying to read from a variable that didn't exist that means that either the _clients array isn't what you think it is, or that cid is an empty string when you don't expect it to be. Initially I had it set to ModelSIM, and Quartus was right to not find the right executables. Similarly, go to Assignments > Settings > EDA Tool Settings > Simulation and do the same. You need to be a bit inventive to figure out what it means, and why the problem might be occurring. To verify, go to Assignments > Settings > EDA Tool Settings and make sure you have ModelSIM-Altera selected under Tool Name. OK, you're looking at a Tcl stack trace thrown by an event callback.
0 kommentar(er)
